Contact information

You can get this candidate's contact information from https://www.work.ua/resumes/20476504/

Work experience

Embedded System Engineer

from 01.2017 to 01.2026 (9 years)
SoftServe (IT)

Education

НУЛП

ІТРЕ Радіоелектронні апарати та засоби, Львів
Higher, from 2009 to 2014 (5 years)

Проектування та виробництво радіоелектронних апаратів.

Knowledge and skills

• STM32
• ESP32
• Interactive prototyping
• PCB design
• KiCad
• SolidWorks
• FreeRTOS
• Barematal
• Embeded
• 3D-моделювання
• 3D printing
• C-Language
• Soldering of radio components
• Sensors

Language proficiencies

English — average

Additional information

Embedded Systems Engineer with 7+ years of experience in full-cycle device development, from concept and prototyping to production-ready PCB and firmware. Strong focus on STM32 and ESP32 platforms, HW/SW integration, low-power systems, and IoT devices. Experienced in schematic design, PCB layout (KiCad), firmware development, and enclosure design for embedded products.

Core Skills/Technical Stack:
1. MCUs & Platforms:
STM32 (F0/F1/L4/F4), ESP32, RP2040, Nordic Semiconductor, Cypress (Infineon).
2. Development Tools:
STM32CubeIDE, Visual Studio Code, ESP-IDF, KiCad, Sketchup, Solidworks, Git, Logic Analyzer, Oscilloscope, power consumption measurements tools.
3. Programming:
Embedded C, Bare-metal, FreeRTOS, low-level drivers, power optimization
4. Communication Protocols:
I2C, UART, SPI, RS485, USB
5. Peripherals & modules:
Sensors (temperature, humidity, pressure, light, accelerometer, gyroscope), RTC, displays (OLED, 7-segment), motor control (servo, stepper), power management (DC/DC), ADC, storage (MicroSD, Flash memory), wireless (NRF24, LoRa, GSM, GPS), ESD protection
6. Hardware Design:
Schematic design and PCB layout (KiCad), prototyping, hardware debugging, testing, and manufacturing support.
7. Practical Experience:
Hands-on experience with SMD soldering (0603, ICs) for prototyping and debugging.
8. Mechanical Design:
Design of enclosures, mounts, and mechanical parts for embedded devices (3D printing, SketchUp, Solidworks).